|
|
Strip
Fork and Strip Clip remove the edge waste completely on their own, without the
need of wooden blocks or frames. This makes it unnecessary to cut and fit wooden
parts on the upper stripping board and provides a clear view of the stripping
process. There is no more a danger of collision between the upper and lower
stripping boards. A distance of 4mm between the Strip Fork and the outer contour
of the lower stripping board ensures sufficient safety. The stripping operation
is the same as for small internal waste. Strip Clips and Strip Forks are positioned
in pairs every 60 to 70mm along the edge waste areas. This configuration removes
edge waste parts with widths of 4 to 5mm without any problems. Material savings
of one to two percent are possible, particularly when producing corrugated-board. |
|
|
|
|
